Кафедра агроінженерії та автомобільного транспорту

Постійне посилання на фонд

https://dspace.pdau.edu.ua/handle/123456789/13829

Переглянути

Перегляд Кафедра агроінженерії та автомобільного транспорту за Ключові слова "bushing"

Зараз показуємо 1 - 1 з 1
  • Ескіз недоступний
    Публікація
    Research into the restoration of parts by plastic deformation
    (2025) Іванкова, Олена Володимирівна; Ivankova, O. V.; Fedin, V.
    Increasing the durability of machines is a priority task of the technical maintenance and repair industry. In modern conditions, the development and implementation of progressive technologies for the restoration of worn machine parts is of particular relevance, which is one of the priority tasks for our country. At the same time, the processes of plastic deformation in the repair of parts currently have limited application, despite their significant potential. This necessitates the need for targeted research into the use of plastic deformation for the restoration of specific machine parts. Hydraulic systems are important components of most machines and mechanisms, and their reliability largely determines the performance of the equipment as a whole. Gear pumps, as key elements of hydraulic systems, operate under conditions of increased loads and intense friction. The main causes of their failures are violations of the adjustment gaps in the mating parts, which arise as a result of reaching the limit of wear, in particular bushings. The article provides an analysis of the operating conditions of gear pumps, as well as characteristic defects and types of wear of their parts. The results of the analysis showed the possibility of restoring worn bushings using plastic deformation methods. The restoration method, the choice of equipment, tools and technological process modes are substantiated, and a rational heat treatment mode is proposed. The conclusion is made about the feasibility and possibility of using plastic deformation to restore gear pump bushings in order to increase their durability. The use of plastic deformation in the restoration of bushings allows you to compensate for the worn layer of material due to a controlled change in the geometric parameters of the part and the formation of a wear-resistant material structure without the formation of a heat-affected zone. The deposition and distribution processes provide an increase in the physical and mechanical properties and dimensional stability of the restored parts, which contributes to the increase in their operational reliability.